Single Switch Turnout/Point Actuator

This turnout/point actuator has been designed for silky smooth operation.
The actuator uses an SG90 servo motor and eccentric drive to transmit the rotary output of the servo into a smooth linear output. It comes supplied fully assembled and tested with a servo.

2 x 1.5 (nominal) diameter pin holes have been provided to suit either a single or double pin drive to suit the intended application.
Drive pins are not provided with the actuator as each will have their own preference, but brass rod or piano wire of a diameter to suit your chosen turnout type can be secured with superglue.
Most customers using PECO or similar turnouts will use a single drive, however the pin hole centres have been spaced at 17.5mm to suit hand-built turnouts built to 18.83mm gauge (P4 standards).

This version of the device features a single microswitch for controlling frog polarity or other accessories.

A mounting template is included in the instructions and mounting holes can be pilot-drilled from above the baseboard to simplify fitting.

The geometry of the mounting holes and drive pin spacing is consistent across the range, so should it be necessary to change to an alternative switch combination then this can be readily achieved without realignment problems.

A dedicated electronic control system for these actuators will be available in due course, but all commonly available servo controllers will operate these units well.

Please see my YouTube video regarding these actuators for further details:
https://youtu.be/HfyN7Z_CxPY

For European orders please select 'Netherlands' as the shipping destination. The website software requires me to list each country separately., and there isn't an EU option. If you select 'Netherlands', the correct shipping cost will be applied.
Please note, import taxes seem to be charged inconsistently, and are beyond my control. They will be the purchasers responsibility.